07-31-2020, 01:23 AM
I have a Raspberry PI 3b+ connected through a VGA666 to a CRT Monitor. I'm currently running Retropie + EmulationStation + RetroArch 1.7.6 at 800x600x85Hz using HDMI_TIMINGS in my config.txt.
When I go into Retroarch config, I set CRT Super Resolution to 1920. As soon as I toggle CRT Switch Res to ON, the monitor shuts off. I tried turning the monitor back on, but it says No Signal. The monitor definitely supports 1920; 1920x1440x75 Hz is one of its native resolutions.
Am I missing something obvious? Thanks for any help!
When I go into Retroarch config, I set CRT Super Resolution to 1920. As soon as I toggle CRT Switch Res to ON, the monitor shuts off. I tried turning the monitor back on, but it says No Signal. The monitor definitely supports 1920; 1920x1440x75 Hz is one of its native resolutions.
Am I missing something obvious? Thanks for any help!